Guide: The daily maintenance and regular maintenance of the label barcode printer is to ensure the quality and long-term performance of the barcode printer.
The label bar code printer is a special type of printer. The daily maintenance and regular maintenance of the label bar code printer is to ensure the quality and long-term performance of the bar code printer. The more frequently the bar code printer is used, the more often it should be cleaned.
Print head cleaning
To clean the print head regularly and regularly, the cleaning tool can be used with cotton swabs and alcohol. Turn off the power of the barcode printer. Keep the same direction when wiping (to avoid residual dirt when rubbing back and forth), turn the print head up, remove the ribbon, label paper, and use a cotton swab (or cotton cloth) dipped in the print head cleaning solution. , wipe the print head until it is clean. Then dry the printhead gently with a clean cotton swab. Keep the print head clean to get good print results, and most importantly, extend printhead life.
Rubber stick cleaning and maintenance
To regularly and regularly clean the bar code printer glue stick, the cleaning tool can use cotton swabs and alcohol to keep the glue stick clean, also to get good printing results and extend the life of the print head. During the printing process, the label paper will leave a lot of powder on the glue stick. If it is not cleaned in time, it will hurt the print head. The glue stick has been used for a long time. If there is wear or some unevenness, it will affect the printing and damage the print head. .
Roller cleaning
After cleaning the print head, clean the rollers with a cotton swab (or cotton cloth) soaked in 75% alcohol. The method is to scrub the roller while rubbing it by hand, and after it is clean, dry it. The cleaning interval of the above two steps is generally three days. If the barcode printer is used frequently, it is best to do it once a day.
Cleaning of the drive system and cleaning inside the chassis
Because the general label paper is self-adhesive, the glue is easy to stick to the shaft and channel of the transmission, and dust is added, which directly affects the printing effect, so it needs to be cleaned frequently. Usually once a week, the method is to scrub the shaft of the transmission, the surface of the channel and the dust inside the chassis with a cotton swab (or cotton cloth) soaked in alcohol, clean and dry.
Sensor cleaning
Keep the sensor clean so that no paper measurement errors or ribbon errors occur. The sensor includes a ribbon sensor and a label sensor. The location is described in the manual. It is usually cleaned from three months to six months by scrubbing the sensor head with a cotton swab dipped in alcohol. After cleaning, dry it.
Paper guide cleaning
The guide groove generally does not have a big problem, but sometimes the manual or label quality problem causes the label to stick inside the guide groove, so it is also necessary to clean it in time.
The temperature is generally maintained between 10-24
Can not be too high, otherwise it is easy to reduce the life of the print head, pay attention to the ribbon and label combination, generally coated paper with wax-based ribbon, synthetic paper with half-tree or full-tree ribbon. In addition, the label paper should be kept flat, so do not make it uneven, otherwise the print head will be easily worn.
Red Light Therapy is a skin care treatment being offered as an alternative to physician administered laser therapy. Most studies involving red light therapy revolve around the treatment of acne, rosacea, and of its ability to get rid of wrinkles. While research is not yet conclusive on the benefits of red light therapy, studies suggest that concentrated red light is absorbed by the mitochondria in the cells and stimulates the generation of more collagen
Infrared Face Therapy,Infrared Therapy Pad,Heat Therapy Infrared Pad
Shenzhen Bonliter Optoelectronic Co., Ltd. , https://www.szbonliter.com