[ Chinese wardrobe network ] I believe that for short-term tenants or students, cloth wardrobe is a very popular product, its practicality and cost-effective are praised by consumers. But for some friends, after purchasing the cloth closet, how to install it becomes difficult. Below, Xiaobian will introduce you to the installation method of the cloth wardrobe in detail, and friends who are interested can come and find out!
How to install the cloth closet - ready to work
First, when you receive an item, whether it is a courier or a direct purchase, be sure to check the package for serious damage. Open the package, and then check whether the accessories inside are complete. There is a manual, check the instructions. If there are few, it is estimated that you can't install it without using it. Therefore, the number of advances is clear, so as not to be wasted. When installing, be sure to wear gloves. And must read the instructions carefully.
How to install the cloth closet - installation method
1. First install the bottom one, take out the four-way joint with the bottom and the high, and connect with the short tube in the middle. Install a four-way joint on each side, then install the tube on both sides, decide the position of the place, and install the long tube. Install a short tube on one side. Then install the base fabric on both sides, and then install a three-way joint around each other.
2. After installing the bottom, insert six short steel pipes, then put the whole wardrobe cloth up against the surrounding holes. Then install a layer of the same partition as the bottom, then put it on the six steel pipes. Floor. If the wardrobe is divided on two sides, first install the short-side floor, first insert the side steel pipe, then install the cloth, then connect the four-way joint, then install two horizontal steel pipes, then install the cloth, then Then make up the four-way joint on both sides. Repeat the baffle until it is attached to the top.
3. After the short-side partition is installed, the long side is a vertical hanging area, and a three-way joint is used to connect the two long tubes to the top. After the topmost steel pipe is installed on both sides, the long steel pipe is directly used. Connected, so the wardrobe is installed. If the wardrobe is too high, not enough to squeeze, it is recommended to push the side up. So as not to install it. At the same time, the hanging steel pipe can also be installed with a hook-type joint, this is relatively simple. When the cloth cover is at the top of the large set, it is best to pull the bottom to the top, so that there is space to pull up, until the upper corner is installed diagonally. At this time, the cloth cover can be pulled down. The wardrobe is installed. When loading, the first short tube should be inserted first. When the four tubes are installed, the side of the width of the wardrobe is first installed, and then the two sides are installed. This is good, otherwise the width is limited. Good fit. Long can be opened, the width can not be pulled. Remember!
Although the installation of the cloth wardrobe is not very troublesome, it takes some time to install it. When the friends install the cloth wardrobe, they must carefully study the installation instructions and then proceed with the operation. Otherwise, it is very likely that the installation is safe. Caused rework. And in order to ensure the quality of the cloth wardrobe, when buying, do not only focus on the price factor, or pay more attention to the quality of the product. For more inquiries, please log in to Comfort 100!
Serving Spoon,Salad Spoons,Gold Serving Utensils,Serving Spoon Sets
Taizhou Polybest Household Product Co.,Ltd , https://www.polycutlery.com